U - Up (port-channel) F - Fallback Activated Ports 1/1/53 and 1/1/54 are port channel members, and (P) indicates each is up and active.įlags: D - Down I - member up but inactive P - member up and active The VLTi is automatically configured as a static LAG using port channel 1000. Port channels 96-97 (numbers may vary) are automatically created spine uplinks. Port channel 1 (number may vary) is the L2 uplink. The show port-channel summary command is used to view port channel numbers, interfaces used, and status. Port Description Status Speed Duplex Mode Vlan Tagged-VlansĮth 1/1/56 up 100G full - show port-channel summary S5248F-Leaf1A# show interface status | grep up In this example, ports 1/1/1-1/1/3 are VxRail nodes, port 1/1/9:1 is a jump host, ports 1/1/49-1/1/52 are the VLTi, ports 1/1/53-1/1/54 are uplinks to the external network, and ports 1/1/55-1/1/56 are uplinks to the spines. The show interface status | grep up command is used to verify required interfaces are up, and links are established at their appropriate speeds.

Note: If SmartFabric OS10 was factory installed, a perpetual license is already on the switch. License location: /mnt/license/690ZZP2.lic Installation instructions are provided in the Dell EMC SmartFabric OS10 User Guide on Dell EMC Networking OS10 Info Hub. If an evaluation license is installed, licenses purchased from Dell are available for download on Dell Digital Locker. The License Type: field should indicate PERPETUAL. Run the command show license status to verify license installation. Note: See the SmartFabric OS10 release notes for upgrade instructions. SmartFabric OS10 is available on Dell Digital Locker (account required).Ĭopyright (c) 1999-2019 by Dell Inc. Run the show version command to check the OS version.

Leaf and spine switches must be running a supported version of SmartFabric OS10. This section provides a list of the most common commands and their output for the examples used in this guide.

Software lag switch activation key 1.2